How To Connect Pex To Threaded Pipe

How To Connect Pex To Threaded Pipe. If using a threaded fitting, the side connecting the pvc pipe must be a male plastic fitting. Place the ring or clamp over the end of the pex that you want to connect to the copper tubing.

Joining dissimilar pipe Plumbing & HVAC
Joining dissimilar pipe Plumbing & HVAC from plumbingandhvac.ca

Place the ends of the pipes together. Pex tubing is crimped onto the male end, and the female end is either soldered or threaded onto existing pipe. Click on to see full reply.

This Method Requires Soldering The Adapter To The Copper Pipe Before Fitting The Pex To The Other End And Securing With A.

There are two parts to this transition: Place the ring or clamp over the end of the pex that you want to connect to the copper tubing. For a crimp connection, you will need a pex crimping tool and rings.

This Convenience, However, Comes At A Price.

Traditionally, connecting pex to copper depends on the end of the pipe you’re connecting to. Center the coupling on the pipe joint, and mark a pencil line on each pipe at each end of the coupling. This type of fitting can also connect pex to pex.

Make Sure That The End Of The Pex Tubing Is Cut Squarely So It Will Fit Evenly Over The End Of The Fitting.

They are the simplest to connect and don’t even require tools to attach pvc to pex to make the connection, just insert the pex pipe into one end of the fitting; Place the ends of the pipes together. Cut the pex to the desired length and insert the ring into the end of the pipe.

If The Pipe Is Not Threaded, You May Use A Male Or Female Slip Adapter.

This method will also require using pipe dope and tape to ensure the seal is good. Clamp the ring with a clamp. Then slip the ring on the pex.

Put The Pex Tubing With Threaded Ends Together And Slide The Teflon Tape Onto Both Of Those Threads As Well, Making Sure That It Is Snugged.

Whether the adapter fitting is threaded on the galvanized pipe or soldered to copper, connect to the existing pipe. Match the adapter to the present pipe first. Position it where the end of the tubing will cover the fitting.

Leave a Reply

Your email address will not be published.