How To Clean Maytag Washer Filter Top Load

How To Clean Maytag Washer Filter Top Load. Did you know that your washing machine has a lint filter trap that needs to be cleaned out? Use a stiff acid brush to remove any remaining dirt or debris.

Reviews, Chews & HowTos Howto Deep Clean a TopLoading
Reviews, Chews & HowTos Howto Deep Clean a TopLoading from rchreviews.blogspot.com

Pay extra attention to knobs and electronic panels. Remove any items left in the tub. To begin the simple process, you are going to need to fill your washer up with hot water.

Perform The Following Procedure Occasionally Or Every 6 Months.

Remove remaining residue from the filter by rinsing with water. After you’ve done a proper clean on your maytag front loader washer, you must run a washing and spinning cycle to remove all the washing ingredients. Clean in and around the door.

Then Remove The Drain Pump Filter By Turning It Counterclockwise.

Some filters are disposable, so instead of cleaning them you can just throw them away and put a new one in place. Close the door and select your washer’s cleaning cycle. Close the door and select your washer’s cleaning cycle.

During Drain Down And Spin, The Water Forces The Lint Off The Bottom Of The Filters And Down The Drain.

Here is how you access and clean the filter in your maytag front. For top load washers, when the cycle ends, run a rinse and spin cycle to clear away any excess cleansers. On front load washers, use the textured side of the wipe to clean the outside of the rubber door seal.

Wipe Away Dust, Grime, And Laundry Product Drips From The Top And Sides Of The Washer.

Perform the following procedure occasionally or every 6 months. How do you clean a maytag washer with vinegar and baking soda? Use a small brush to clean the filter before replacing it.

Open The Two Screws On Both Sides Of The Front Panel Using A Flathead Screwdriver.

Open the front panel to clean a washer. Cleaning the drain pump filter/draining residual water on your maytag front load washer. Open the washer door and inspect the door and sides of the door opening for a compartment cover piece that will be long and thin.

Leave a Reply

Your email address will not be published.